Axis Communications M5013 Manual de usuario descargar pdf (Pagina 34)

AXIS M5013 PTZ Dome Network Camera

System Options

To change the date and time settings, select the preferred Time mode under New Server Time:

• Synchronize with computer time sets date and time according to the computer’s clock. With this option, date and

time are set once and will not be updated automatically.

• Synchronize with NTP Server obtains date and time from an NTP server. With this option, date and time settings are

updated continuously. For information on N TP settings, see NTP Conﬁguration, on page 35.

If using a host name for the NTP server, a DNS server must be conﬁgured. See DNS Conﬁguration, on page 35.

• Set manually allows you to manually s et date and time.

If using an NTP server, select your Time zone from the dro p-down list. If required, check Automatically adjust for daylight saving

time changes.

The Date & Time Format U sed in Images is the date and time format displayed as a text overlay in the video stream. Use the

predeﬁned formats or see File Naming & Date/Time Formats in the online help

for information on how to create custom date and

time formats. To include date and time in the overlay text, go to Video & Audio and select Include date and Include time.

Network

Basic TCP/IP Settings

The Axis product supports IP version 4 and IP version 6. Both versions can be enabled simultaneously, and at least one version

must always be enabled.

IPv4 Address Conﬁguration

By default, the Axis product is set to use IPv4 (IP version 4) and to obtain the IP address automatically via DHCP. The IPv4 settings are

conﬁgured under System Options > Network > TCP/IP > Basic.

DHCP (Dynamic Host Conﬁguration Protocol) allows network administrators to centrally manage and automate the assignment of

IP addresses. DHCP should only be enabled if using dynamic IP address notiﬁcation, or if the DHCP can update a DNS server. It is

then possible to access the Axis product by name (host name).

If DHCP is e n abl ed and the product cannot be accessed, run AXIS IP Utility to search the netwo rk for connected Axis products, or reset

the product to the factory default settings (see page 41) and then perform the installation again.

To use a static IP address, check Use the following IP address and specify the IP address, subnet mask and default router.

IPv6 Address Con ﬁguration

If IPv6 (IP version 6) is enabled, the Axis p roduct will receive an IP address according to the conﬁguration in the network router.

To enable IPv6, go to System Options > Network > TCP/IP > Basic. Other settings for IPv6 should be conﬁgured in the network router.

ARP/Ping

The IP address can be set using ARP and Ping . For instructions, see the product’s Installation Guide.

ARP/Ping is ena bled by default. To disable, uncheck the box under System Options > Network > TCP/IP > Basic.

The ARP/Ping service is automatically disabled two minutes after the product is started, or as soon as an IP address is set. To reset the

IP address, the product must be restarted to activate ARP/Ping for an additional two minutes.

Pinging the product is still possible when this service is disabled.

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 49 50

Sin comentarios

Axis Communications M5013 Manual de usuario Pagina 34