Axis Communications P1343 Manual de usuario descargar pdf (Pagina 6)

AXIS P1343 Network Camera

Hardware overview

Connectors

Network connector - RJ-45 Ethernet connector. Supports Power over Ethernet (PoE).

Caution

To protect the product against power surges, a shielded network cable (STP) must be used between the product and the

network switch. Ensure that the network switch is properly grounded.

Audio in (pink) - 3.5 mm input for a mono microphone, or a line-in mono signal (left channel is used from a stereo signal).

Audio out (green) - 3.5 mm output for audio (line level) that c an be connected to a public address (PA) system or an active s peaker

with a built-in a mpliﬁer. A stereo connector must be used fo r the audio out.

SD card slot - A standard or high-capacity SD card (not included) can be used for local recording with removable storage. For

instructions on how to insert and remove an SD card, please r efer to the Installation Guide.

Note

Before removal, the SD card should be unmounted to prevent corruption of recordings. To unmount the SD card, go to Setup

>SystemOptions>Storage>SDCardand click Unmount.

Control button - The control button is used for:

• Enabling the Focus A ssistant. Press and very quickly release the C ontrol button.

• ConnectingtoanAXISVideoHostingSystemservice.Seepage 41. To connect, press and hold the button for about

1 second until the Status LED ﬂashes green.

• ConnectingtoAXISInternetDynamicDNSService. Seepage 41. To connect, press and hold the button for

about 3 seconds.

• Resetting the product to factory default settings. See page 47.

Power connector - 2-pin terminal block for power input.

I/O connector

DC power input

Note

For technical speciﬁc

ations, see page 54.

I/O terminal connector - Use in applications for e.g. motion detection, event triggering, time lapse recording and alarm notiﬁcations.

In addition to an auxiliary pow e r and a GND pin, the I/O terminal connector provides the interface to:

• Digital output

— For connecting external devices such as relays and LEDs. Connected devices can be activated by

the VAPIX® Application Prog ramm ing Interface, output buttons on the Live View page or by an Action Rule. The

output will show as active (shown under System Options > Ports & Devices) if the alarm device is activated.

1 2 3 4 5 6 7 8 9 10 11 ... 57 58

Sin comentarios

Axis Communications P1343 Manual de usuario Pagina 6